Recommendations:
*DISCLAIMER* The links underneath are all Affiliate links but,
I have personally tested them all and can vouch for them.
Elegoo Gray PLA
The filament I use for my grey dungeon/stone tiles. I’ve tried many different brands and colors, but this particular one is both strong, gives good quality prints and have the right look for stone tiles.
Deeplee Brown PLA
The filament I use for my wooden tiles. This particular one have one of the best colors for wooden tiles, that I’ve tried. It’s strong. The quality is good and the prints look great.
Adhesive Spray for 3D Print
I use an adhesive spray for all my prints along with the Bambu Textured Plate. It solves 99.9% of my adhesion issues.
(Unfortunately, PrintaFix or DimaFix which I personally use isn’t available, so you’ll have to find out which brand works best for you)
Reusable Desiccant Beads
To dry my filament, I use reusable desiccant beads that pulls the moisture from the air around the filament. I keep the beads in Mesh Laundry Bags for easy application.
Mesh Laundry Bags
I use these Mesh Laundry Bags to store the reusable desiccant beads in. When they are full, I just put the bag inside my printer for 24-48 hours with the bed set to 90 degrees (celcius). After that, they are as good as new.
IMPORTANT: Amazon might suggest another type of mesh bags, depending on your location. Make sure the mesh is suitable for small beads